Signex CPT96D25 (used)

Bantam patchbay with D-Sub 25 connections

• Two rows of bantam jacks in the space of one rack unit
• Special construction of jacks to keep out dust and dirt
• Rear termination with direct soldering of D-sub 25 pins
• Partial or full normalization available on all channels
• Balanced/unbalanced and for stereo signals available
• Can be equipped with support bar to provide solid support for cables
• Quick and easy writing and correction of identification markings for connections
• Available for insert function without the need for special cables
• Version with palladium contacts
• Parallel PCB points for each jack

Signex Isopatch Bantam is based on the same design that made the Isopatch so popular, but uses the 4.4 mm "Bantam" jack widely accepted in professional studios. The Bantam Jack, designed and built to withstand the heavy use encountered in a professional environment, offers superior contact performance in a much smaller space. The dual Bantam jack used in the Isopatch Bantam has a closed design that helps keep out contaminants that reduce contact life, with spacing to accept two "stereo" plugs.

The contacts are silver- or gold-plated phosphor bronze with optional solid palladium contacts. All components are mounted on two horizontal printed circuit boards (PCBs) that make the Isopatch Bantam very solid and give full access to most circuits, including parallel points and special "programming pads" for normalization. The use of flexible jumper cables between upper and lower PCBs means that Isopatch Bantam can be opened for maintenance if necessary.

Unlike conventional permutation panels, Isopatch offers partial or full normalization on each channel simply by soldering special "programming pads" on the upper PCB, without the need for tedious wiring. In fact, if the Isopatch Bantam is already installed, it is not even necessary to disconnect the rear connectors. The redesigned PCB now offers 25-way D-sub connectors wired to the Tascam 38/88 model, so wiring can be done separately, then simply plugged in place. Alternatively, direct-solder versions with on-board cable clamps are available for each channel.

The Isopatch can be used for most types of audio signals, including mono, stereo, balanced and unbalanced lines. It can also be used for mixer insert points without the need for special "splitter" cables